Product Description


This 13.56 MHz RFID card uses advanced cryptography to prevent tag cloning and is an ideal solution for access control and asset tracking.


This is a blank 13.56MHz RFID/NFC card – often used for train/bus passes but also found in other systems where a proximity card is desired. The tag contains a small RFID chip and an antenna and is passively powered by the reader/writer when placed a couple inches away.

These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle?ISO/IEC 14443 Type A cards as there are a few other encoding standards (like Felicia) They are tested and work great with both our?PN532 NFC/RFID breakout board?and?Adafruit NFC/RFID Shield for Arduino!

These chips can be written to & store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writes. Can you use our?PN532 NFC/RFID breakout board?or?Adafruit NFC/RFID Shield for Arduino?to read and write data to the EEPROM inside the tag. There is also a permanent 4-byte ID burned into the chip that you can use to identify one tag from another – the ID number cannot be changed.

These use a?ISO/IEC 14443 Type A chipset, which used to be the ‘classic’ NFC chipset. In ~2014, the NFC forum decided not to support this chipset anymore, so newer phones do not support it. This only matters if you’re trying to use this tag with a phone/tablet.


There are no reviews yet.

Be the first to review “13.56MHz RFID Card IN PAKISTAN”